The applications for our products
Chambrelan slides are reliable and robust products. Mounted on the major axis,in pairs, with a load distributed uniformly, Chambrelan slides will give you complete satisfaction.
The rules for good mounting are simple :
- Use of all fixings provided,
- Make sure the slide are parallel,
- For locking slides make sure the slides stop equal to eachother,
- Make sure the bearing areas are even.
Protective hood of control desk
Mounted on RA44 slides, this hood prevents access to the control desk by unauthorized people.
NB : The slides can be flat mounted on the minor axis because the load to be withstood in extension is minimal.
Boxes fitted with slides
These industrial batteries mounted in boxes have to be taken out with a minimum of stress. Accessibility, easy removing and remounting are vital.
In this case, the solution consists of fitting brackets with locating pins onto the slides.
The nitruration operation enables the mechanical qualities of the slides to be improved as well as offering reinforced protection.
All the equipment available on an emergency vehicle must be rapidly available and installed in the easiest and most efficient way possible. The use of slides will make the movement and utilisation of equipment and accessories as varied as a motor-driven pump, a winch or a cable reel, much easier.
Some equipment in an emergency vehicle has to be taken out of its storage space rapidly and be put into operation instantly.
The slides meet the rescuers' needs perfectly, thanks to their rugged design as well as the safety margins built into the stated load capacity.
In addition, the slides offer strong resistance to vibration thanks to the workhardening hardening of the profiles.
This 2 part cabinet has to open to allow the technicians internal access.
This low cost solution enables space to be saved and improves the access for and cost of maintenance.
NB : The considerable height of the drawer compelled us to use stabilising slides in the upper part to avoid a "swinging" effect.
Removing the coin safe door before opening.
The safe is 3 cm deep. Its door must be as close to the safe as possible to prevent any attempted damage or break-in.
In order to make the opening of this door possible, the hinges have been mounted on 75mm long slides with total extension.